diff --git a/worldsemi/addressable-led/WS2812B/SOURCES.md b/worldsemi/addressable-led/WS2812B/SOURCES.md index 80a3ab9..b8af67c 100644 --- a/worldsemi/addressable-led/WS2812B/SOURCES.md +++ b/worldsemi/addressable-led/WS2812B/SOURCES.md @@ -5,3 +5,25 @@ - **Source URL**: https://cdn-shop.adafruit.com/datasheets/WS2812B.pdf - **Retrieval date**: 2026-07-01 - **Vendor**: WorldSemi (mirrored on Adafruit CDN) + +## Silicon revisions V6 and V7 + +Both received directly from WorldSemi on 2026-11-09, in reply to a FastLED +enquiry. The vendor filenames were kept as shipped, so the revision is visible +in the name. + +- **File**: `WS2812B-V6_EN.pdf` +- **Original filename**: `WS2812B-V6_EN.pdf` (not renamed) +- **Document revision**: V1.5 (footer), 9 pages +- **Source**: WorldSemi, attached to the email "Worldsemi WS2812B-V6 Datasheet and V6/V7 Current Consumption Clarification", 2026-11-09 +- **Vendor**: WorldSemi (world-semi.com) + +- **File**: `WS2812B-V7_EN.pdf` +- **Original filename**: `WS2812B-V7_EN.pdf` (not renamed) +- **Document revision**: V1.3 (footer), 9 pages +- **Source**: same email as above +- **Vendor**: WorldSemi (world-semi.com) + +Neither revision is mirrored at a public URL, so the vendor email is the +provenance. See `current-consumption.md` for the idle-vs-transmit current +clarification that came with them. diff --git a/worldsemi/addressable-led/WS2812B/WS2812B-V6_EN.pdf b/worldsemi/addressable-led/WS2812B/WS2812B-V6_EN.pdf new file mode 100644 index 0000000..b2af325 Binary files /dev/null and b/worldsemi/addressable-led/WS2812B/WS2812B-V6_EN.pdf differ diff --git a/worldsemi/addressable-led/WS2812B/WS2812B-V7_EN.pdf b/worldsemi/addressable-led/WS2812B/WS2812B-V7_EN.pdf new file mode 100644 index 0000000..18e690c Binary files /dev/null and b/worldsemi/addressable-led/WS2812B/WS2812B-V7_EN.pdf differ diff --git a/worldsemi/addressable-led/WS2812B/current-consumption.md b/worldsemi/addressable-led/WS2812B/current-consumption.md new file mode 100644 index 0000000..78542d1 --- /dev/null +++ b/worldsemi/addressable-led/WS2812B/current-consumption.md @@ -0,0 +1,36 @@ +# WS2812B V6 / V7 current consumption + +Vendor clarification supplied with the V6 and V7 datasheets +(`WS2812B-V6_EN.pdf`, `WS2812B-V7_EN.pdf`) on 2026-11-09. It corrects a common +modelling error: the sub-microamp figure is an **idle** number and must not be +used to estimate draw while the part is being driven. + +| Condition | Current | +|---|---| +| No data signal (quiescent / idle) | **< 1 µA** | +| During data transmission (IC operating current) | **≈ 150 µA** | + +Quoting the vendor: the "< 1 µA" specification *"applies to the idle state +without data transmission and should not be used directly to estimate +consumption during"* transmission. + +## Why it matters for a power model + +These figures are the **IC's own** supply current — they exclude the LED dice, +which dominate total draw and are set by PWM brightness, not by this number. +Treat 150 µA as the per-pixel logic overhead to add on top of the LED current +when a frame is being clocked out, and 1 µA only when the bus is idle. Using +1 µA as the active figure understates the chip's contribution by roughly 150×. + +## Brightness difference between the revisions + +The vendor also states that **V7 delivers three times the brightness of V6**. +That is a property of the rev, not a datasheet typo: two boards that look +identical can differ by 3× in luminous output depending on which silicon they +carry, so record the revision when comparing measurements. + +## Provenance limit + +The figures above are from the vendor's email of 2026-11-09 and are reproduced +here as a supplement to the PDFs; where the PDFs disagree, the PDFs win. Neither +number was measured by FastLED.